Siemens SINAMICS G150 - CO;BO: Control Word Sequence Control Encoder DO; STW Seq_Ctrl Encdo; CO;BO: Control Word Sequence Control; STW Seq_Ctrl; CO;BO: Status Word Sequence Control Infeed; ZSW Seq_Ctrl INF

SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
267
2 Parameters
2.2 List of parameters
Description: Display and connector output for the control word of the sequence control for encoder drive object.
Description: Display and connector output for the control word of the sequence control.
Note: OC: Operating condition
Description: Display and BICO output for the status word of the sequence control of the infeed unit.
Bit field: Bit Signal name 1 signal 0 signal FP
00 Synchronization signal SYN Yes No -
01 Real time synchronization PING Yes No -
07 Acknowledge fault Yes No -
12 Master sign-of-life bit 0 Yes No -
13 Master sign-of-life bit 1 Yes No -
14 Master sign-of-life bit 2 Yes No -
15 Master sign-of-life bit 3 Yes No -
r0898.10 CO/BO: Control word sequence control encoder DO / STW seq_ctrl encDO
ENC Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Displays, signals Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
10 Master ctrl by PLC Yes No -
r0898.0...14 CO/BO: Control word sequence control / STW seq_ctrl
VECTOR_G Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: 2501
P-Group: Displays, signals Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 ON/OFF1 Yes No -
01 OC / OFF2 Yes No -
02 OC / OFF3 Yes No -
03 Operation enable Yes No -
04 Ramp-function generator enable Yes No -
05 Continue ramp-function generator Yes No -
06 Speed setpoint enable Yes No -
07 Command open brake Yes No -
08 Jog 1 Yes No 3001
09 Jog 2 Yes No 3001
10 Master ctrl by PLC Yes No -
12 Speed controller enable Yes No -
14 Command close brake Yes No -
r0899.0...12 CO/BO: Status word sequence control infeed / ZSW seq_ctrl INF
B_INF Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: 8726
P-Group: Displays, signals Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Rdy for switch on Yes No -
01 Ready Yes No -
02 Operation enabled Yes No -
04 No OFF2 active OFF2 inactive OFF2 active -