Siemens SINAMICS G150 - SI Motion SBT Control Word Diagnostics; SBT STW Diag; CO;BO: si Safety Info Channel Status Word S_ZSW3 B; SIC S_ZSW3 B

2 Parameters
2.2 List of parameters
SINAMICS G130/G150
998 List Manual (LH2), 04/2014, A5E03263479A
[3] = Select test torque sign
[4] = Select test sequence
[5] = External brake status
Note: Re BI: p10230[0]:
0/1 signal: select brake test.
0 signal: inactive.
Re BI: p10230[1]:
0/1 signal: start brake test.
Re BI: p10230[2]:
1 signal: select brake 2.
0 signal: select brake 1.
Re BI: p10230[3]:
1 signal: select negative test torque.
0 signal: select positive test torque.
Re BI: p10230[4]:
1 signal: select test sequence 2.
0 signal: select test sequence 1.
Re BI: p10230[5]:
1 signal: external brake closed.
0 signal: external brake open.
Description: Displays the diagnostic bits for the control word of the safe brake test
Dependency: Refer to: p10203
Note: The bits indicate the actual control signals of the control set in p10203.
Description: Display and BICO output for status word S_ZSW3B of the safety information channel.
r10231 SI Motion SBT control word diagnostics / SBT STW diag
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: 2836, 2837
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Select brake test Yes No -
01 Start brake test Yes No -
02 Select brake Brake 2 Brake 1 -
03 Select test torque sign Negative Positive -
04 Select test sequence Test sequence 2 Test sequence 1 -
05 External brake status Closed Open -
r10234.0...15 CO/BO: SI Safety Info Channel status word S_ZSW3B / SIC S_ZSW3B
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: 2836
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Brake test selected Yes No -
01 Setpoint input drive/external Drive External -
02 Active brake Brake 2 Brake 1 -
03 Brake test active Yes No -
04 Brake test result Successful With error -
05 Brake test completed Yes No -
06 External brake request Close Open -
07 Actual load sign Negative Positive -