Siemens SINAMICS G150 - Sensor Module EEPROM Data Version; SM EEPROM Version; Sensor Module Firmware Version; SM FW Version; Number of VSM Data Sets; VSM Dat_Sets Qty.; DRIVE-Cliq Hub Module Component Number; Hub Comp_No

2 Parameters
2.2 List of parameters
SINAMICS G130/G150
92 List Manual (LH2), 04/2014, A5E03263479A
Value: 0: Component inactive
1: Component active
Dependency: Refer to: p0105, p0145, p0480, p0897
Description: Displays the version of the EEPROM data of the Sensor Module.
Dependency: Refer to: r0127, r0157
Note: Example:
The value 1010100 should be interpreted as V01.01.01.00.
Description: Displays the firmware version of the Sensor Module.
Dependency: Refer to: r0018, r0128, r0158, r0197, r0198
Note: Example:
The value 1010100 should be interpreted as V01.01.01.00.
Description: Sets the number of VSM data sets.
Description: This parameter is used to assign the data set to a DRIVE-CLiQ Hub Module.
This unique component number is assigned when parameterizing the topology.
Only the numbers of components operated as hubs can be entered in these parameters.
[0] = DRIVE-CLiQ node 1
[1] = DRIVE-CLiQ node 2
r0147[0...n] Sensor Module EEPROM data version / SM EEPROM version
ENC, VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: EDS, p0140 Func. diagram: -
P-Group: Encoder Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r0148[0...n] Sensor Module firmware version / SM FW version
ENC, VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: EDS, p0140 Func. diagram: -
P-Group: Encoder Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
p0150 Number of VSM data sets / VSM dat_sets qty.
VECTOR_G Can be changed: C1(3) Calculated: - Access level: 4
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: Data sets Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
1 2 1
p0151[0...1] DRIVE-CLiQ Hub Module component number / Hub comp_no
HUB Can be changed: C1(4) Calculated: - Access level: 3
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: Data sets Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 199 0