Siemens SINAMICS G150 - Status Word, Monitoring Functions 3

SINAMICS G130/G150 List Manual (LH2), 04/2014, A5E03263479A
1105
3 Function diagrams
3.6 Internal control/status words
Fig. 3-66 2537 – Status word, monitoring functions 3
Function diagram
- 2537 -
87654321
fp_2537_51_eng.vsd
DO: SERVO, VECTOR, VECTOR3P, VECTORGL, VECTORM2C, VECTORMV, VECTORSL
SINAMICS
15.10.13 V04.07.00
Internal control/status words - Status word, monitoring functions 3
11
12
13
14
15
1 = |n_act| < speed threshold value 3 (p2161)
Status word, monitoring functions 3
1 = f or n comparison value reached or exceeded (p2141)
Reserved
Reserved
1 = Speed setpoint - actual value deviation within tolerance t_on
1 = Ramp-up/ramp-down completed
0 = Ramp-function generator active
1 = Current below the zero current threshold
Speed deviation model/external in tolerance
Reserved
Reserved
Reserved
1 = Torque utilization < torque threshold value 2 (p2194)
1 = Excitation current outside the tolerance range
Reserved
Reserved
Reserved
PROFIdrive bit
9
10
8
7
6
5
4
3
2
1
0
Bit No.
P0115[4]
From torque signals [8012.5]
From speed signals 2 [8011.8]
From speed signals 1 [8010.8]
From speed signals 1 [8010.8]
r2199
ZSW monitoring functions 3
r2199.11
r2199.5
r2199.1
r2199.0
<1>
<1>n_act = smoothed speed actual value r2169 [8010.2].
[8012.1]
From speed signals 2 [8011.8]
r2199.4
r2199.6
r2199.12
r2199.7From torque signals [8012.8]