Siemens SINAMICS G150 - BI: Sync-Line-Drive Enable; Sync Enable; CO;BO: Sync-Line-Drive Control Word; Sync STW; CO: Sync-Line-Drive Target Frequency; Sync F_Target; CO: Sync-Line-Drive Frequency Difference; Sync F_Diff

2 Parameters
2.2 List of parameters
SINAMICS G130/G150
578 List Manual (LH2), 04/2014, A5E03263479A
Description: Sets the signal source to switch in/switch out for the line-drive synchronization.
BI: p3802 = 1 signal:
The line-drive synchronization is switched in.
Dependency: Refer to: p3800, p3801
Description: Displays the control word for the line-drive synchronization.
Note: Re bit 00:
For a 1 signal, p3800 > 0 is set.
Description: Displays the target frequency for the line-drive synchronization.
Description: Displays the frequency difference between the measured target frequency and output frequency of the gating unit of
the closed-loop control for line-drive synchronization.
p3802[0...n] BI: Sync-line-drive enable / Sync enable
VECTOR_G Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dyn. index: CDS, p0170 Func. diagram: 7020
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0
r3803.0 CO/BO: Sync-line-drive control word / Sync STW
VECTOR_G Can be changed: - Calculated: - Access level: 2
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Sync-line-drive selected Yes No -
r3804 CO: Sync-line-drive target frequency / Sync f_target
VECTOR_G Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3030, 7020
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Scaling: p2000 Expert list: 1
Min Max Factory setting
- [Hz] - [Hz] - [Hz]
r3805 CO: Sync-line-drive frequency difference / Sync f_diff
VECTOR_G Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 7020
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Scaling: p2000 Expert list: 1
Min Max Factory setting
- [Hz] - [Hz] - [Hz]