Siemens SINAMICS G150 - PN Device ID; PN Device ID; IE Name of Station Active; IE Name Stat Act; IE IP Address of Station Active; IE IP of Stat Act; IE Default Gateway of Station Active; IE Def Gateway Act

2 Parameters
2.2 List of parameters
SINAMICS G130/G150
822 List Manual (LH2), 04/2014, A5E03263479A
Description: Displays the PROFINET Device ID.
Every SINAMICS device type has its own PROFINET Device ID and its own PROFINET GSD.
Note: List of the SINAMICS Device IDs:
0501 hex: S120/S150
0504 hex: G130/G150
050A hex: DC MASTER
050C hex: MV
050F hex: G120P
0510 hex: G120C
0511 hex: G120 CU240E-2
0512 hex: G120D
0513 hex: G120 CU250S-2 Vector
0514 hex: G110M
Description: Displays the active station name for the Industrial Ethernet interface (X127) on the Control Unit.
Description: Displays the active IP address for the Industrial Ethernet interface (X127) on the Control Unit.
Description: Displays the active default gateway for the Industrial Ethernet interface (X127) on the Control Unit.
r8909 PN device ID / PN device ID
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r8910[0...239] IE Name of Station active / IE Name Stat act
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: - Calculated: - Access level: 1
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r8911[0...3] IE IP Address of Station active / IE IP of Stat act
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: - Calculated: - Access level: 1
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 255 -
r8912[0...3] IE Default Gateway of Station active / IE Def Gateway act
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: - Calculated: - Access level: 1
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 255 -