2 Parameters
2.2 List of parameters
SINAMICS G130/G150
726 List Manual (LH2), 04/2014, A5E03263479A
Description: Setting to upload and save the trace data of the component trace.
Experts can then evaluate this data.
For p7792 = 1, the trace data of the component is written to files on the memory card in a non-volatile fashion.
The parameter is then automatically set to zero.
Value: 0: Inactive
1: Upload and save active
Dependency: Refer to: p7790, p7791
Notice: Trace files of this component already available on the non-volatile storage medium are overwritten after backup has
been activated.
Description: Sets the component number of the DRIVE-CLiQ component whose parameters are to be accessed.
Dependency: Refer to: p7821, p7822, r7823
Description: Sets the parameter number to access a parameter of a DRIVE-CLiQ component.
Dependency: Refer to: p7820, p7822, r7823
Description: Sets the parameter index to access a parameter of a DRIVE-CLiQ component.
Dependency: Refer to: p7820, p7821, r7823
p7792 Upload component trace data / Upload comp trace
B_INF, VECTOR_G Can be changed: U, T Calculated: - Access level: 4
Data type: Integer16 Dyn. index: - Func. diagram: -
P-Group: Converter Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0
p7820 DRIVE-CLiQ component component number / DQ compo_no
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: U, T Calculated: - Access level: 4
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 65535 0
p7821 DRIVE-CLiQ component parameter number / DQ para_no
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: U, T Calculated: - Access level: 4
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 65535 0
p7822 DRIVE-CLiQ component parameter index / DQ para_index
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: U, T Calculated: - Access level: 4
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 65535 0
To Next Page
Loading...
