Siemens SINAMICS G150 - OA Invalid Number; OA Inv No.; OA DO-Specific Logbook Module Selection; OA DO Log Module; OA Invalid Identifier Total Length; OA Inv ID Tot_Lgth; OA Invalid Identifier; OA Inv ID

2 Parameters
2.2 List of parameters
SINAMICS G130/G150
686 List Manual (LH2), 04/2014, A5E03263479A
Description: Only for service purposes.
Description: Displays the number of invalid OA applications installed on the memory card/device memory.
Dependency: Refer to: r4976, r4978, r4979
Note: OA: Open Architecture (OA application)
Description: Displays the total length of the IDs of all the invalid OA applications installed on the memory card/device memory.
Dependency: Refer to: r4975, r4978, r4979
Note: The identifier of an invalid OA application comprises a maximum of 8 characters plus separator.
Description: Displays the IDs of all the invalid OA applications installed on the memory card/device memory.
r4978[0...8]: Identifier of invalid OA application 1
r4978[9...17]: Identifier of invalid OA application 2, ...
Dependency: Refer to: r4975, r4976, r4979
Notice: If there is no invalid OA application, then it is not possible to access an index.
p4961[0...n] OA DO-specific logbook module selection / OA DO log module
All objects Can be changed: T Calculated: - Access level: 4
Data type: Unsigned32 Dyn. index: r4950 Func. diagram: -
P-Group: OEM range Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0000 hex FFFF FFFF hex 0000 hex
r4975 OA invalid number / OA inv no.
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: - Calculated: - Access level: 4
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: OEM range Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r4976 OA invalid identifier total length / OA inv ID tot_lgth
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: - Calculated: - Access level: 4
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: OEM range Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r4978[0...n] OA invalid identifier / OA inv ID
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: - Calculated: - Access level: 4
Data type: Unsigned8 Dyn. index: r4976 Func. diagram: -
P-Group: OEM range Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -