Siemens SINAMICS G150 - Page 1151

SINAMICS G130/G150 List Manual (LH2), 04/2014, A5E03263479A
1151
3 Function diagrams
3.12 Setpoint channel
Fig. 3-106 3010 – Fixed speed setpoints
- 3010 -
Function diagram
87654321
fp_3010_51_eng.vsd
DO: SERVO, VECTOR, VECTOR3P, VECTORGL, VECTORM2C, VECTORMV, VECTORSL
SINAMICS
16.10.13 V04.07.00
Setpoint channel - Fixed speed setpoints
0 0 1 1
0 1 0 1
0 1 1 0
0 1 1 1
1 0 0 1
1 0 1 0
1 0 1 1
1 1 0 0
1 1 0 1
1 1 1 0
1 1 1 1
0 0 0 1
0 0 1 0
n_set_fixed 1 [rpm]
p1001[D] (0.000)
n_set_fixed 2 [rpm]
p1002[D] (0.000)
n_set_fixed 3 [rpm]
p1003[D] (0.000)
n_set_fixed 4 [rpm]
p1004[D] (0.000)
n_set_fixed 5 [rpm]
p1005[D] (0.000)
n_set_fixed 6 [rpm]
p1006[D] (0.000)
n_set_fixed 7 [rpm]
p1007[D] (0.000)
n_set_fixed 8 [rpm]
p1008[D] (0.000)
n_set_fixed 9 [rpm]
p1009[D] (0.000)
n_set_fixed 10 [rpm]
p1010[D] (0.000)
n_set_fixed 11 [rpm]
p1011[D] (0.000)
n_set_fixed 12 [rpm]
p1012[D] (0.000)
n_set_fixed 13 [rpm]
p1013[D] (0.000)
n_set_fixed 14 [rpm]
p1014[D] (0.000)
n_set_fixed 15 [rpm]
p1015[D] (0.000)
p1001[D]
p1003[D]
p1002[D]
p1004[D]
p1005[D]
p1006[D]
p1007[D]
p1008[D]
p1009[D]
p1010[D]
p1011[D]
p1012[D]
p1013[D]
p1014[D]
p1015[D]
0.000
n_set_fixed No act
r1197
<100>
Fixed speed setpoint selection bit 0
r1198.0
Fixed speed setpoint selection bit 1
r1198.1
Fixed speed setpoint selection bit 2
r1198.2
Fixed speed setpoint selection bit 3
r1198.3
From
control word
setpoint
channel
0 0 0 0
0 1 0 0
1 0 0 0
[2505.3]
p1020
[2505.3]
p1021
[2505.3]
p1022
[2505.3]
p1023
<101>
<100> For SERVO, the following applies:
Only if the function module "extended setpoint
channel" is activated (r0108.8 = 1).
<101> Pre-assignment of the sampling times in p0115,
refer to p0112.
p0115[3]
r1024
n_set_fixed eff [rpm]