Siemens SINAMICS G150 - Page 1176

3 Function diagrams 3.14 Vector control
SINAMICS G130/G150
1176 List Manual (LH2), 04/2014, A5E03263479A
Fig. 3-129 6491 – Flux control configuration
- 6491 -
Function diagram
87654321
DO: VECTOR
S120/S150/G130/G150
12.07.13 V04.07.00
Vector control - Flux control configuration
1
2
1 = Flux setpoint, soft starting active
Meaning
1 = Flux setpoint, differentiation active
1 = Flux build-up control active
0
Bit No.
Flux control, configuration
[6723.6]
[6722.3]
p1401[D]
p1401[D]
F_ctrl config
[6723.7]1
1
0
Factory setting
3 1 = Flux characteristic, load-dependent 1
4 1 = Flux controller (ASM with encoder) 1
1 = Flux impression with model chngov (ASM with encoder)
0 = Flux impression from 30 % n_rated (ASM with encoder)
15
6 1
7 Reserved
3 Reserved8
Reserved9
10 Reserved
11 Reserved
12 Reserved
1 = Quick magnetizing
13 Reserved
14 Reserved
15 Reserved
p0115[2] (Motor Modules)
fp_6491_54_eng.vsd
[6725.2]
[6722.5]