ABB AC500 PLC - Page 1092

Name Value Internal value Internal
value, type
Default
Handshake mode None 0 BYTE 0
XON/XOFF 2
Baudrate Channel inactive 0 DWORD 19200
300 bit/s 300
1200 bit/s 1200
4800 bit/s 4800
9600 bit/s 9600
14400 bit/s 14400
19200 bit/s 19200
38400 bit/s 38400
38400 bit/s 57600
57600 bit/s 57600
115200 bit/s 115200
Parity No parity 0 BYTE No parity
Odd parity 1
Even parity 2
Data bits 5 bits 0 BYTE 8
6 bits 1
7 bits 2
8 bits 3
Stop bits 1 bit 0 BYTE 1
2 bits 1
Configuration with Automation Builder
The physical layers are selectable as submodules in PROFINET configuration
(parameter Physical Layer not visible and fixed with the correct value). Certain
parameters are not visible if a certain physical layer is selected. This concept of
parameterization provides a better usability than configuring via GSDML (see
below).
Configuration via GSDML (use by non-ABB PROFINET configuration tool)
All parameters are visible independent of the configured physical layer (via
parameter “Physical Layer” ). The user must take precautions for each param-
eter since certain parameter values are invalid for certain physical layers. Nev-
ertheless, the CI5xx-PNIO module performs a parameter check depending on
the configured physical layer and generates a diagnosis message (parameter
error) in the case of error.
Device Specifications
Communication Interface Modules (S500) > PROFINET
2019/04/173ADR010121, 13, en_US1092