PROGRAMMING CABLE TK503 / TK504
4 3ADR020159M0201, 1, en_US
2 Installation
2.1 Installation Steps
Before you can use the TK503/TK504 programming cable, the appropriate USB driver must be
installed on your PC or laptop.
The driver for the TK503/TK504 programming cable is installed in two steps:
– Pre-installation of the driver on your PC using the program
TK503_TK504_Installer.exe
.
– Installation of the new hardware in Windows after the TK503 programming cable or TK504
programming cable is plugged in for the first time.
NOTICE!
Before you connect the TK503/TK504 programming cable with the PC, install the
USB driver first.
2.2 Pre-Installation Routine
1. Uninstall all existing versions of the driver software.
2. Start the pre-installation of the driver by calling
TK503_TK504_Installer.exe.
NOTICE!
You must have administrator rights to run the installation.
3. Define the installation directory and click Install.
To Next Page
Loading...
