ABB AC500 PLC - Page 591

E1...E4 d1 d2 d3 d4 Identifier
000...063
AC500
display
<− Display in
Class Comp Dev Mod Ch Err PS501
PLC
browser
Byte 6
Bit 6...7
- Byte 3 Byte 4 Byte 5 Byte 6
Bit 0...5
FBP diag-
nosis
block
Class Interface Device Module Channel Error
Identifier
Error message Remedy
1
)
2
)
3
)
4
)
4 14 1...10 3
20...21
7
)
7 Analog value underflow
at an analog output
Check
output
value
11 / 12 ADR 1...10
Remarks:
1
)
In AC500, the following interface identifier applies:
14 = I/O bus, 11 = COM1 (e.g. CS31 bus), 12 = COM2.
The FBP diagnosis block does not contain this identifier.
2
)
With "Device" the following allocation applies:
31 = module itself,
1...10 = decentralized communication interface module 1...10,
ADR = hardware address (e.g. of the DC551)
3
)
With "Module" the following allocation applies depending on the master:
Module error: I/O bus or FBP: 31 = module itself; COM1/COM2: 1...10 = expan-
sion 1...10
Channel error: I/O bus or FBP = module type (1 = AI, 3 = AO, 4 = DC); COM1/
COM2: 1...10 = expansion 1...10
4
)
In case of module errors, with channel "31 = module itself" is output.
5
)
Ch = 22...29 indicates the digital inputs/outputs DC16...DC23
6
)
Ch = 16...19 indicates the analog inputs AI0...AI3
7
)
Ch = 20...21 indicates the analog outputs AO0...AO1
Device Specifications
I/O Modules > Digital/Analog I/O Modules
2019/04/17 3ADR010121, 13, en_US 591