4-7
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 4 Turn Up Node
NTP-A169 Set Up CTC Network Access
Step 6 To change the extreme high battery voltage threshold in 0.5 VDC increments, choose a voltage from the
EHIBATVGVdc drop-down list.
Step 7 Click Apply.
Stop. You have completed this procedure.
NTP-A169 Set Up CTC Network Access
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66. If you are already logged in, continue with
Step 2.
Step 2 Complete the “DLP-A249 Provision IP Settings” task on page 19-30 to provision the ONS 15454 IP
address, subnet mask, default router, DHCP server, IIOP listener port, and SOCKS proxy server settings.
Tip If you cannot log into the node, you can change its IP address, default router, and network mask
by using the LCD on the ONS 15454 fan-tray assembly (unless LCD provisioning is
suppressed). See the “DLP-A64 Set the IP Address, Default Router, and Network Mask Using
the LCD” task on page 17-71 for instructions. However, you cannot use the LCD to provision
any other network settings.
Step 3 If you want to turn on the ONS 15454 secure mode, which allows two IP addresses to be provisioned for
the node if TCC2P cards are installed, complete the “DLP-A433 Enable Node Security Mode” task on
page 21-11.
Step 4 If static routes are needed, complete the “DLP-A65 Create a Static Route” task on page 17-73. Refer to
the “CTC Network Connectivity” chapter in the Cisco ONS 15454 Reference Manual for further
information about static routes.
Step 5 If the ONS 15454 is connected to a LAN or WAN that uses OSPF and you want to share routing
information between the LAN/WAN and the ONS network, complete the “DLP-A250 Set Up or Change
Open Shortest Path First Protocol” task on page 19-34.
Step 6 If the ONS 15454 is connected to a LAN or WAN that uses RIP, complete the “DLP-A251 Set Up or
Change Routing Information Protocol” task on page 19-36.
Stop. You have completed this procedure.
Purpose This procedure provisions network access for a node, including its subnet
mask, default router, Dynamic Host Configuration Protocol (DHCP)
server, IIOP (Internet Inter-Orb Protocol) listener port, SOCKS proxy
server settings, static routes, Open Shortest Path First (OSPF) protocol,
and Routing Information Protocol (RIP).
Tools/Equipment None
Prerequisite Procedures NTP-A24 Verify Card Installation, page 4-2
Required/As Needed Required
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
Need help?
General
