Cisco ONS 15454 Series - DLP- A264 Provision a J1 Path Trace on Circuit Source and Destination Ports

19-46
Cisco ONS 15454 Procedure Guide, R5.0
September 2005
Chapter 19 DLPs A200 to A299
DLP-A264 Provision a J1 Path Trace on Circuit Source and Destination Ports
Note Cisco recommends that you set the DRI port HOT value to zero and the circuit path selector HOT value
to a number equal to or greater than zero.
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Circuits tab.
Step 3 Click the path protection circuit you want to edit, then click Edit.
Step 4 In the Edit Circuit window, click the UPSR Selectors tab.
Step 5 Create a hold-off time for the circuit source and destination ports:
a. In the Holder Off Timer area, double-click the cell of the circuit source port (top row), then type the
new hold-off time. The range is 0 to 10,000 ms in increments of 100.
b. In the Hold-Off Timer area, double-click the cell of the circuit destination port (bottom row), then
type the hold-off time entered in Step a.
Step 6 Click Apply, then close the Edit Circuit window by choosing Close from the File menu.
Step 7 Return to your originating procedure (NTP).
DLP-A264 Provision a J1 Path Trace on Circuit Source and Destination Ports
Note This task assumes you are setting up path trace on a bidirectional circuit and setting up transmit strings
at the circuit source and destination.
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Circuits tab.
Step 3 For the STS circuit you want to monitor, verify that the source and destination ports are on a card that
can transmit and receive the path trace string. See Table 19-3 for a list of cards.
Purpose This task creates a path trace on STS circuit source ports and destination
ports or a VCAT circuit member.
Tools/Equipment ONS 15454 cards capable of transmitting and receiving path trace must be
installed at the circuit source and destination ports. See Table 19-3 on
page 19-47 for a list of cards.
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher