EasyManuals Logo

Cisco ONS 15454 Series User Manual

Cisco ONS 15454 Series
850 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #113 background imageLoading...
Page #113 background image
CHAPTER
4-1
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
4
Turn Up Node
This chapter explains how to provision a single Cisco ONS 15454 node and turn it up for service,
including assigning a node name, date and time, timing references, network attributes such as IP address
and default router, users and user security, and card protection groups.
Before You Begin
Complete the procedures applicable to your site plan from the following chapters:
Chapter 1, “Install the Shelf and Backplane Cable”
Chapter 2, “Install Cards and Fiber-Optic Cable”
Chapter 3, “Connect the PC and Log into the GUI”
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1. NTP-A24 Verify Card Installation, page 4-2—Complete this procedure first.
2. NTP-A30 Create Users and Assign Security, page 4-4—Complete this procedure to create
Cisco Transport Controller (CTC) users and assign their security levels.
3. NTP-A25 Set Up Name, Date, Time, and Contact Information, page 4-4—Continue with this
procedure to set the node name, date, time, location, and contact information.
4. NTP-A261 Set Power Monitor Thresholds, page 4-6—Continue with this procedure to set the node
battery power thresholds.
5. NTP-A169 Set Up CTC Network Access, page 4-7—Continue with this procedure to provision the
IP address, default router, subnet mask, and network configuration settings.
6. NTP-A27 Set Up the ONS 15454 for Firewall Access, page 4-8—Continue with this procedure if
the ONS 15454 will be accessed behind firewalls.
7. NTP-A28 Set Up Timing, page 4-9—Continue with this procedure to set up the node’s SONET
timing references.
8. NTP-A170 Create Protection Groups, page 4-10—Complete this procedure, as needed, to set up 1:1,
1:N, 1+1, or Y-cable protection groups for ONS 15454 electrical and optical cards.
9. NTP-A256 Set Up SNMP, page 4-12—Complete this procedure if Simple Network Management
Protocol (SNMP) will be used for network monitoring.

Table of Contents

Other manuals for Cisco ONS 15454 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ONS 15454 Series and is the answer not in the manual?

Cisco ONS 15454 Series Specifications

General IconGeneral
Supported InterfacesEthernet
ManagementCisco Transport Controller (CTC), TL1, SNMP
Power Supply-48 VDC or AC (depending on power supply module)
Operating Temperature0 to 50°C (32 to 122°F) - varies by module
Storage Temperature-40°C to 70°C (-40 to 158°F)
Relative Humidity5 to 95%, noncondensing
Supported ProtocolsSONET/SDH, Ethernet, OTN
Platform TypeMulti-service transport platform

Related product manuals