4-4
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 4 Turn Up Node
NTP-A30 Create Users and Assign Security
NTP-A30 Create Users and Assign Security
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66 at the node where you need to create users.
If you are already logged in, continue with Step 2.
Note You must log in as a Superuser to create additional users. The CISCO15 user provided with each
ONS 15454 can be used to set up other ONS 15454 users. You can add up to 500 users to one
ONS 15454.
Step 2 Complete the “DLP-A74 Create a New User on a Single Node” task on page 17-82 or the “DLP-A75
Create a New User on Multiple Nodes” task on page 17-83 as needed.
Note You must add the same user name and password to each node a user will access.
Step 3 If you want to modify the security policy settings, including password aging and idle user timeout
policies, complete the “NTP-A205 Modify Users and Change Security” procedure on page 10-6.
Stop. You have completed this procedure.
NTP-A25 Set Up Name, Date, Time, and Contact Information
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66 for the node you will turn up. If you are
already logged in, continue with Step 2.
Step 2 Click the Provisioning > General tabs.
Purpose This procedure creates ONS 15454 users and assigns their security levels.
Tools/Equipment None
Prerequisite Procedures NTP-A24 Verify Card Installation, page 4-2
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
Purpose This procedure provisions identification information for the node,
including the node name, a contact name and phone number, the location
of the node, and the date, time, and time zone.
Tools/Equipment None
Prerequisite Procedures NTP-A24 Verify Card Installation, page 4-2
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
Need help?
General
