Cisco ONS 15454 Series User Manual

20-73
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A386 Install Electrical Cables on the UBIC-V EIAs
Figure 20-16 Partially Cabled UBIC-V
Step 5
If available, tie wrap or lace the cables to the tie bar according to Telcordia standards (GR-1275-CORE)
or local site practice.
Note When routing the electrical cables, be sure to leave enough room in front of the alarm and timing
panel so that it is accessible for maintenance activity.
Step 6 Return to your originating procedure (NTP).
115075

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform