CHAPTER
11-1
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
11
Change Card Settings
This chapter explains how to change line provisioning, thresholds, and service states on Cisco
ONS 15454 cards.
Before You Begin
Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15454 Troubleshooting Guide as necessary.
Caution Changing card settings can be service affecting. You should make all changes during a scheduled
maintenance window.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1. NTP-A88 Modify Line Settings and PM Parameter Thresholds for Electrical Cards, page 11-2—As
needed, complete this procedure to change line and threshold settings for all electrical cards (EC-1,
DS-1, DS-3, DS3i-N-12, and DS3XM).
2. NTP-A89 Modify Line Settings and PM Parameter Thresholds for OC-N Cards, page 11-2—As
needed, complete this procedure to change line and threshold settings for all optical (OC-N) cards.
3. NTP-A90 Modify Alarm Interface Controller Settings, page 11-3—As needed, complete this
procedure to change external alarms and controls (environmental alarms) and/or orderwire settings.
4. NTP-A118 Modify Alarm Interface Controller-International Settings, page 11-4—As needed,
complete this procedure to change external alarms and controls and/or orderwire settings.
5. NTP-A91 Upgrade DS-1 and DS-3 Protect Cards from 1:1 Protection to 1:N Protection, page
11-4—As needed, complete this procedure to change the protection type on DS-1 or DS-3 cards.
6. NTP-A315 Modify Port Settings and PM Parameter Thresholds for FC_MR-4 Cards, page 11-5—As
needed, complete this procedure to change FC_MR-4 card port and threshold settings.
7. NTP-A297 Change Card Service State, page 11-6—As needed, complete this procedure to change
card service state.
To Next Page
Loading...
Need help?
General
