Cisco ONS 15454 Series User Manual

19-56
Cisco ONS 15454 Procedure Guide, R5.0
September 2005
Chapter 19 DLPs A200 to A299
DLP-A273 Modify SNMP Trap Destinations
Step 9 In the Select Applicable Nodes area, uncheck any nodes where you do not want to apply the changes.
Step 10 Click OK.
Step 11 In the Security Policy Change Results dialog box, confirm that the changes are correct, then click OK.
Step 12 Return to your originating procedure (NTP).
DLP-A273 Modify SNMP Trap Destinations
Step 1 In node view, click the Provisioning > SNMP tabs.
Step 2 Select a trap from the Trap Destinations area.
For a description of SNMP traps, refer to the “SNMP” chapter in the Cisco ONS 15454 Troubleshooting
Guide.
Step 3 Highlight the Destination row field entry under the Community column and change the entry to another
valid community name.
Note The community name is a form of authentication and access control. The community name
assigned to the ONS 15454 is case-sensitive and must match the community name of the network
management system.
Note The default UDP port for SNMP is 162.
Step 4 Set the Trap Version field to either SNMPv1 or SNMPv2.
Refer to your network management system (NMS) documentation to determine whether to use SNMP
v1 or v2.
Step 5 If you want the SNMP agent to accept SNMP SET requests on certain MIBs, click the Allow SNMP Sets
check box. If this box is not checked, SET requests are rejected.
Step 6 If you want to set up the SNMP proxy feature to allow network management, message reporting, and
performance statistic retrieval across ONS firewalls, click the Enable SNMP Proxy check box located
on the SNMP tab.
Step 7 Click Apply.
Purpose This task modifies the Simple Network Management Protocol (SNMP) trap
destinations on an ONS 15454 including community name, default User
Datagram Protocol (UDP) port, SNMP trap version, and maximum traps
per second.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform