19-20
Cisco ONS 15454 Procedure Guide, R5.0
September 2005
Chapter 19 DLPs A200 to A299
DLP-A231 Edit a Circuit Name
CTC will not change the service state of the circuit source and destination port in certain circumstances.
For example, if a port is in loopback (OOS-MA,LPBK & MT), CTC will not change the port to IS-NR.
In another example, if the circuit size is smaller than the port, such as a VT1.5 circuit on an STS port,
CTC will not change the port service state from IS-NR to OOS-MA,DSBLD. If CTC cannot change the
port service state, you must change the port service state manually. For more information, see the
“DLP-A214 Change the Service State for a Port” task on page 19-9.
Step 9 Return to your originating procedure (NTP).
DLP-A231 Edit a Circuit Name
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Circuits tab.
Step 3 If you want to edit a VCAT circuit member name, complete the following steps in the Edit Circuit
window. If not, continue with Step 4.
a. Click the Members tab.
b. Click the VCAT member that you want to edit, then click Edit Member. The Edit Member window
appears.
Step 4 In the General tab, click the Name field and edit or rename the circuit.
Note Names can be up to 48 alphanumeric and/or special characters. However, to ensure that a
monitor circuit can be created on this circuit, do not make the name longer than 44 characters
because monitor circuits will add “_MON” (four characters) to the circuit name.
Step 5 Click Apply.
Step 6 From File menu, choose Close.
Step 7 If you changed the name of a VCAT circuit member, repeat Step 6 for the Edit Circuit window.
Step 8 In the Circuits window, verify that the circuit was correctly renamed.
Step 9 Return to your originating procedure (NTP).
Purpose This task edits the name of a circuit or VCAT member.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
Need help?
General
