18-11
Cisco ONS 15454 Procedure Guide, R5.0
March 2007
Chapter 18 DLPs A100 to A199
DLP-A124 Refresh PM Counts at 15-Minute Intervals
DLP-A124 Refresh PM Counts at 15-Minute Intervals
Step 1 In node view, double-click the card where you want to view PM counts. The card view appears.
Step 2 Click the Performance tab.
Step 3 Click the 15 min radio button.
Step 4 Click Refresh. Performance monitoring parameters appear in 15-minute intervals synchronized with the
time of day.
Step 5 View the Curr column to find PM counts for the current 15-minute interval.
Each monitored performance parameter has corresponding threshold values for the current time period.
If the value of the counter exceeds the threshold value for a particular 15-minute interval, a threshold
crossing alert (TCA) is raised. The number represents the counter value for each specific performance
monitoring parameter.
Step 6 View the Prev-n columns to find PM counts for the previous 15-minute intervals.
Note If a complete 15-minute interval count is not possible, the value appears with a yellow
background. An incomplete or incorrect count can be caused by monitoring for less than
15 minutes after the counter started, changing node timing settings, changing the time zone
settings, replacing a card, resetting a card, or changing port service states. When the problem is
corrected, the subsequent 15-minute interval appears with a white background.
Step 7 Return to your originating procedure (NTP).
DLP-A125 Refresh PM Counts at One-Day Intervals
Purpose This task changes the window view to display PM counts in 15-minute
intervals.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
Purpose This task changes the window view to display PM parameters in 1-day
intervals.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
Need help?
General
