Cisco ONS 15454 Series User Manual

17-8
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 17 DLPs A1 to A99
DLP-A8 Open the Front Door
Step 3 Repeat the task with the remaining shelves.
Step 4 Return to your originating procedure (NTP).
DLP-A8 Open the Front Door
Note The ONS 15454 has an ESD plug input and is shipped with an ESD wrist strap. The ESD plug input is
located on the outside edge of the shelf assembly on the right-hand side. It is labeled “ESD” on the top
and bottom. Always wear an ESD wrist strap and connect the strap to the ESD plug when working on
the ONS 15454.
Step 1 Open the front door lock (Figure 17-3).
The ONS 15454 comes with a pinned hex key for locking and unlocking the front door. Turn the key
counterclockwise to unlock the door and clockwise to lock it.
Step 2 Press the door button to release the latch.
Step 3 Swing the door open.
Purpose This task describes how to open the front cabinet compartment door.
Tools/Equipment Pinned hex key
Prerequisite Procedures None
Required/As Needed Required
Onsite/Remote Onsite
Security Level None

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform