20-16
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A326 Change a BLSR Node ID
Step 7 Return to your originating procedure (NTP).
DLP-A326 Change a BLSR Node ID
Step 1 From the View menu, choose Go to Network View.
Step 2 On the network map, double-click the node with the node ID you want to change.
Step 3 Click the Provisioning > BLSR tabs.
Step 4 Choose a Node ID number. Do not choose a number already assigned to another node in the same BLSR.
Step 5 Click Apply.
Step 6 Return to your originating procedure (NTP).
DLP-A327 Configure the CTC Alerts Dialog Box for Automatic Popup
Step 1 Click the CTC Alerts toolbar icon.
Step 2 In the CTC Alerts dialog box, choose one of the following:
• All alerts—Sets the CTC Alerts dialog box to open automatically for all notifications.
• Error alerts only—Sets the CTC Alerts dialog box to open automatically for circuit deletion errors
only.
• Never—Sets the CTC Alerts dialog box to never open automatically.
Step 3 Click Close.
Purpose This task changes a BLSR node ID.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task sets up the CTC Alerts dialog box to open for all alerts, for circuit
deletion errors only, or never. The CTC Alerts dialog box displays network
disconnection, Send-PDIP inconsistency, circuit deletion status, condition
retrieval errors, and software download failure.
Tools None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
Need help?
General
