Cisco ONS 15454 Series User Manual

22-5
Cisco ONS 15454 Procedure Guide, R5.0
October 2005
Chapter 22 DLPs A500 to A599
DLP-A515 Print CTC Data
DLP-A515 Print CTC Data
Step 1 Click the tab (and subtab, if present) containing the information you want to print. For example, click
the Alarms tab to print Alarms window data.
The print operation is available for all network, node, and card view windows.
Step 2 From the File menu, choose Print.
Step 3 In the Print dialog box, click a printing option (Figure 22-2).
• Entire Frame—Prints the entire CTC window including the graphical view of the card, node, or
network. This option is available for all windows.
• Tabbed View—Prints the lower half of the CTC window containing tabs and data. The printout
includes the selected tab (on top) and the data shown in the tab window. For example, if you print
the History window Tabbed View, you print only history items appearing in the window. This option
is available for all windows.
• Table Contents—Prints CTC data in table format without graphical representations of shelves,
cards, or tabs. This option applies to all windows except:
– Provisioning > General > General and Power Monitor windows
– Provisioning > Network > General and RIP windows
– Provisioning > Security > Policy, Access, and Legal Disclaimer windows
– Provisioning > SNMP window
– Provisioning > Timing window
– Provisioning > UCP > Node window
– Provisioning > WDM-ANS > Provisioning window
– Maintenance > Cross-Connect > Cards window
– Maintenance > Database window
– Maintenance > Diagnostic window
– Maintenance > Protection window
– Maintenance > Timing > Source window
The Table Contents option prints all the data contained in a table and the table column headings. For
example, if you print the History window Table Contents view, you print all data included in the
table whether or not the items appear in the window.
Purpose This task prints CTC card, node, or network data in graphical or tabular
format on a Windows-provisioned printer.
Tools/Equipment Printer connected to the CTC computer by a direct or network connection
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform