18-65
Cisco ONS 15454 Procedure Guide, R5.0
March 2007
Chapter 18 DLPs A100 to A199
DLP-A191 Delete a Card
Step 8 Use a Phillips screwdriver to install the six perimeter screws and bracket screws (P/N 48-0422-01) at
8 to 10 lb-in. (9.2 to 11.5kgf-cm) to secure the cover panel to the backplane (Figure 18-8 on page 18-64).
Install the alarm and timing panel cover and insert and tighten the last perimeter screw.
Figure 18-10 shows a UBIC-V EIA installation.
Figure 18-10 Installing the UBIC-V EIA
Step 9
Return to your originating procedure (NTP).
DLP-A191 Delete a Card
Purpose This task deletes a card from CTC.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
115087
To Next Page
Loading...
