20-8
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A314 Assign a Name to a Port
• Slot—Choose the destination slot.
• Port—If displayed, choose the destination port.
• Channel—These options appear if you chose DCC Tunnel-D1-D3 as the tunnel type. Choose one of
the following:
–
DCC1 (D1-D3)—This is the SDCC.
–
DCC2 (D4-D6)—This is LDCC 1.
–
DCC3 (D7-D9)—This is LDCC 2.
–
DCC4 (D10-D12)—This is LDCC 3.
DCC options do not appear if they are used by the ONS 15454 (DCC1) or other tunnels.
Step 8 Click Finish.
Step 9 Put the ports that are hosting the DCC tunnel in service. See the “DLP-A214 Change the Service State
for a Port” task on page 19-9 for instructions.
Step 10 Return to your originating procedure (NTP).
DLP-A314 Assign a Name to a Port
Step 1 Double-click the card that has the port you want to provision.
Step 2 Click the Provisioning tab.
Step 3 Click the Port Name column for the port number to which you are assigning a name.
Step 4 Type the port name.
The port name can be up to 32 alphanumeric/special characters. The field is blank by default.
Step 5 Click Apply.
Step 6 Return to your originating procedure (NTP).
Purpose This task assigns a name to a port on any ONS 15454 card.
Tools/Equipment None
Prerequisite Procedures NTP-A24 Verify Card Installation, page 4-2
DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
