17-74
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 17 DLPs A1 to A99
DLP-A67 Provision the IIOP Listener Port on the ONS 15454
DLP-A67 Provision the IIOP Listener Port on the ONS 15454
Note If the Enable SOCKS Proxy Server on port 1080 check box is checked, CTC will use Port 1080 and
ignore the configured IIOP port setting. If Enable SOCKS Proxy Server is subsequently unchecked, the
configured IIOP listener port will be used.
Step 1 In node view, click the Provisioning > Network > General tabs.
Step 2 In the TCC CORBA (IIOP) Listener Port area, choose a listener port option:
• Default - TCC Fixed—Select this option if the ONS 15327s are on the same side of the firewall as
the CTC computer or if no firewall is used (default). This option sets the ONS 15454 listener port
to Port 57790. It can be used for access through a firewall if Port 57790 is open.
• Standard Constant—Select this option to use Port 683, the CORBA default port number, as the
ONS 15454 listener port.
• Other Constant—If Port 683 is not used, type the IIOP port specified by your firewall
administrator.
Step 3 Click Apply.
Step 4 When the Change Network Configuration message appears, click Yes .
Both ONS 15454 TCC2/TCC2P cards reboot, one at a time. The reboot takes approximately 15 minutes.
Step 5 Return to your originating procedure (NTP).
DLP-A68 Provision the IIOP Listener Port on the CTC Computer
Step 1 From the Edit menu, choose Preferences.
Purpose This task sets the Internet Inter-ORB Protocol (IIOP) listener port on the
ONS 15454, which enables you to access ONS 15454s that reside behind
a firewall.
Tools/Equipment IIOP listener port number provided by your LAN or firewall administrator
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task selects the IIOP listener port on CTC.
Tools/Equipment IIOP listener port number from LAN or firewall administrator.
Prerequisite Procedures NTP-A24 Verify Card Installation, page 4-2
DLP-A60 Log into CTC, page 17-66
Required/As Needed Required only if the computer running CTC resides behind a firewall.
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
