Cisco ONS 15454 Series - Figure 18-3 Node View Alarm Behavior Window

18-6
Cisco ONS 15454 Procedure Guide, R5.0
March 2007
Chapter 18 DLPs A100 to A199
DLP-A117 Apply Alarm Profiles to Cards and Nodes
Figure 18-3 Node View Alarm Behavior Window
Step 2
To apply profiles to a card:
a. Click a selection from the Profile column for the card.
b. Choose the new profile from the drop-down list.
c. Click Apply.
Step 3 To apply the profile to an entire node:
a. Click the Node Profile drop-down arrow at the bottom of the window (Figure 18-3).
b. Choose the new alarm profile from the drop-down list.
c. Click Apply.
Step 4 To reapply a previous alarm profile after you have applied a new one, select the previous profile and click
Apply again.
Step 5 Return to your originating procedure (NTP).