Cisco ONS 15454 Series User Manual

20-9
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A315 Log Out a User on a Single Node
DLP-A315 Log Out a User on a Single Node
Step 1 In node view, click the Provisioning > Security > Active Logins tabs.
Step 2 Choose the user that you want to log out and click Logout.
Step 3 In the Logout User dialog box, check Lockout before Logout if you want to lock the user out. This
prevents the user from logging in after logout, based on parameters provided in the user lockout
parameters provisioned in the Policy tab. A manual unlock by a Superuser is required, or the user is
locked out for the amount of time specified in the Lockout Duration field. See the “DLP-A271 Change
Security Policy on a Single Node” task on page 19-53 for more information.
Step 4 Click OK.
Step 5 Click Yes to confirm the logout.
Step 6 Return to your originating procedure (NTP).
DLP-A316 Log Out a User on Multiple Nodes
Step 1 From the View menu, chose Go to Network View.
Step 2 Click the Provisioning > Security > Active Logins tabs.
Step 3 Choose the user you want to log out.
Step 4 Click Logout.
Step 5 In the Logout User dialog box, check the nodes where you want to log out the user.
Step 6 Check Lockout before Logout if you want to lock the user out prior to logout. This prevents the user
from logging in after logout based on user lockout parameters provisioned in the Policy tab. A manual
unlock by a Superuser is required, or the user is locked out for the amount of time specified in the
Lockout Duration field. See the “DLP-A271 Change Security Policy on a Single Node” task on
page 19-53 for more information.
Purpose This task logs out a user from a single node.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
Purpose This task logs out a user from multiple nodes.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform