18-8
Cisco ONS 15454 Procedure Guide, R5.0
March 2007
Chapter 18 DLPs A100 to A199
DLP-A121 Enable/Disable Pointer Justification Count Performance Monitoring
• 1 to n are the number of STSs on the port. One STS per port can be enabled from the PJSTSMon#
card drop-down list.
Figure 18-4 Enabling or Disabling Pointer Justification Count Parameters
Step 4 In the Service State field, confirm that the port is in the In-Service and Normal (IS-NR) service state.
Step 5 If the port is IS-NR, click Apply. If the port in the Out-of-Service and Management, Disabled
(OOS-MA,DSBLD), OOS-MA,MT, or the Out-of-Service and Autonomous, Automatic In-Service
(OOS-AU,AINS) service state, choose IS from the Admin State drop-down list and click Apply.
Step 6 Click the Performance tab to view performance monitoring (PM) parameters. For PM parameter
definitions, refer to the “Performance Monitoring” chapter in the Cisco ONS 15454 Troubleshooting
Guide.
Note The count fields for PPJC and NPJC PM parameters appear white and blank unless pointer
justification count performance monitoring is enabled.
Step 7 Return to your originating procedure (NTP).
96978
Line tab
Provisioning
tab
Card View
PJSTSMon#
drop-down list
Apply
button
To Next Page
Loading...
Need help?
General
