22-26
Cisco ONS 15454 Procedure Guide, R5.0
October 2005
Chapter 22 DLPs A500 to A599
DLP-A529 Delete Ethernet RMON Alarm Thresholds
Step 5 Click Apply. The new network map appears.
Step 6 Click OK.
Step 7 If the ONS 15454 icons are not visible, right-click the network view and choose Zoom Out. Repeat until
all the ONS 15454 icons are visible. (You can also choose Fit Graph to Window.)
Step 8 If you need to reposition the node icons, drag and drop them one at a time to a new location on the map.
Step 9 If you want to change the magnification of the icons, right-click the network view and choose Zoom In.
Repeat until the ONS 15454 icons are displayed at the magnification you want.
Step 10 Return to your originating procedure (NTP).
DLP-A529 Delete Ethernet RMON Alarm Thresholds
Note The ONS 15454 ML-Series card uses the Cisco IOS CLI for managing RMON.
Step 1 Double-click the Ethernet card where you want to delete the RMON alarm thresholds.
Step 2 In card view, click the Provisioning > RMON Thresholds tabs.
Note For the CE-Series cards, click the Provisioning > Ether Ports > RMON Thresholds tabs or
Provisioning > POS Ports > RMON Thresholds tabs.
Step 3 Click the RMON alarm threshold you want to delete.
Step 4 Click Delete. The Delete Threshold dialog box appears.
Step 5 Click Ye s to delete the threshold.
Step 6 Return to your originating procedure (NTP).
Purpose This task deletes remote monitoring (RMON) threshold crossing alarms
for Ethernet ports.
Tools/Equipment None
Prerequisite Procedures DLP-A533 Create Ethernet RMON Alarm Thresholds, page 22-28
DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
