17-66
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 17 DLPs A1 to A99
DLP-A57 Disable Proxy Service Using Netscape (Windows and UNIX)
DLP-A57 Disable Proxy Service Using Netscape (Windows and UNIX)
Step 1 Open Netscape.
Step 2 From the Edit menu, choose Preferences.
Step 3 In the Preferences dialog box under Category, choose Advanced > Proxies.
Step 4 On the right side of the Preferences dialog box under Proxies, perform one of the following options:
• Choose Direct connection to the Internet to bypass the proxy server.
• Choose Manual proxy configuration to add exceptions to the proxy server, then click View. In the
Manual Proxy Configuration dialog box under Exceptions, enter the IP addresses of the ONS 15454
nodes that you will access. Separate each address with a comma. Click OK to close each open dialog
box.
Note For ONS 15454 nodes that have TCC2P cards installed with the TCC2P secure mode option
enabled, enter the backplane LAN port IP addresses.
Step 5 Return to your originating procedure (NTP).
DLP-A60 Log into CTC
Purpose This task disables proxy service for PCs and UNIX workstations running
Netscape.
Tools/Equipment None
Prerequisite Procedures NTP-A260 Set Up Computer for CTC, page 3-1
Required/As Needed Required if your computer is connected to a network computer proxy server
and your browser is Netscape.
Onsite/Remote Onsite or remote
Security Level None
Purpose This task logs into CTC.
Tools/Equipment None
Prerequisite Procedures NTP-A260 Set Up Computer for CTC, page 3-1
One of the following procedures:
• NTP-A234 Set Up CTC Computer for Local Craft Connection to the
ONS 15454, page 3-2
• NTP-A235 Set Up a CTC Computer for a Corporate LAN Connection
to the ONS 15454, page 3-4
• NTP-A236 Set Up a Remote Access Connection to the ONS 15454,
page 3-5
Required/As Needed Required
To Next Page
Loading...
Need help?
General
