22-28
Cisco ONS 15454 Procedure Guide, R5.0
October 2005
Chapter 22 DLPs A500 to A599
DLP-A533 Create Ethernet RMON Alarm Thresholds
DLP-A533 Create Ethernet RMON Alarm Thresholds
Note The ONS 15454 ML-Series card uses the Cisco IOS CLI for managing RMON.
Step 1 Double-click the Ethernet card where you want to create the RMON alarm thresholds.
Step 2 In card view, click the Provisioning > RMON Thresholds tabs.
Note For CE-Series Ethernet cards, click the Provisioning > Ether Ports > RMON Thresholds tabs
or Provisioning > POS Ports > RMON Thresholds tabs.
Step 3 Click Create.
The Create Ether Threshold dialog box appears (Figure 22-10).
Figure 22-10 Creating RMON Thresholds
Step 4
From the Slot drop-down list, choose the appropriate Ethernet card.
Step 5 From the Port drop-down list, choose the applicable port on the Ethernet card you selected.
Step 6 From the Variable drop-down list, choose the variable. See Table 22-5 and Table 22-6 for a list of the
Ethernet and POS threshold variables available in this field.
Purpose This procedure sets up RMON to allow network management systems to
monitor Ethernet ports.
Tools/Equipment None
Prerequisite Procedures NTP-A24 Verify Card Installation, page 4-2
DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
