20-59
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A373 Install a MiniBNC EIA
Step 6 Use a Phillips screwdriver to install the six perimeter screws and bracket screws (P/N 48-0422-01) at
8 to 10 lbf-inch (9.2 to 11.5 kgf-cm) to secure the cover panel to the backplane (Figure 20-11 on
page 20-58). Install the alarm and timing panel cover and then insert and tighten the last perimeter screw.
Figure 20-13 shows a MiniBNC EIA installation.
Figure 20-13 Installing the MiniBNC EIA
Step 7
Return to your originating procedure (NTP).
115474
To Next Page
Loading...
