8-3
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 8 Monitor Performance
NTP-A122 Monitor Electrical Performance
NTP-A122 Monitor Electrical Performance
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66 at the node that you want to monitor. If you
are already logged in, continue with Step 3.
Step 2 For DS3XM-12 cards complete the following procedures:
• DLP-A394 View DS-N/SONET PM Parameters for the DS3XM-12 Card, page 20-91
• DLP-A395 View BFDL PM Parameters for the DS3XM-12 Card, page 20-93
For all other electrical cards continue with Step 3.
Step 3 In node view, double-click the electrical card where you want to view PM counts. The card view appears.
Step 4 Click the Performance tab (Figure 8-1).
Purpose This procedure enables you to view node near-end or far-end
performance during selected time intervals on an electrical card and port
to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see Chapter 6, “Create Circuits
and VT Tunnels” and Chapter 11, “Change Card Settings.”
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
Need help?
General
