18-26
Cisco ONS 15454 Procedure Guide, R5.0
March 2007
Chapter 18 DLPs A100 to A199
DLP-A159 Delete a User from a Single Node
DLP-A159 Delete a User from a Single Node
Note You cannot delete a user who is currently logged in. To log out a user, you can complete the “DLP-A315
Log Out a User on a Single Node” task on page 20-9, or you can choose the “Logout before delete”
option in the Delete User dialog box.
Note CTC will allow you to delete other Superusers if one Superuser remains. For example, you can delete
the CISCO15 user if you have created another Superuser. Use this option with caution.
Step 1 In node view, click the Provisioning > Security > Users tabs.
Step 2 Choose the user you want to delete.
Step 3 Click Delete.
Step 4 In the Delete User dialog box, verify that the user name displayed is the one you want to delete.
Step 5 Click OK. Confirm that the changes appear; if not, repeat the task.
Step 6 Return to your originating procedure (NTP).
DLP-A160 Change User Password and Security Level on Multiple Nodes
Note You must add the same user name and password to each node the user will access.
Step 1 From the View menu, choose Go to Network View. Verify that you can access all the nodes where you
want to add users.
Step 2 Click the Provisioning > Security > Users tabs. Highlight the user’s name whose settings you want to
change.
Purpose This task deletes an existing user from a single node.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
Purpose This task changes settings for an existing user at multiple nodes.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
Need help?
General
