Cisco ONS 15454 Series User Manual

18-42
Cisco ONS 15454 Procedure Guide, R5.0
March 2007
Chapter 18 DLPs A100 to A199
DLP-A168 Change Line and Threshold Settings for the DS3XM-6 Card
SD BER Sets the signal degrade bit error
rate.
• 1E-5
• 1E-6
• 1E-7
• 1E-8
• 1E-9
Line Type Defines the line framing type.
• M13 - default
• C BIT
Line Coding Defines the DS-1 transmission
coding type that is used.
B3ZS
Line Length Defines the distance (in feet)
from backplane connection to
the next termination point.
• 0 - 225 (default)
• 226 - 450
Admin State Sets the port service state unless
network conditions prevent the
change.
• IS—Puts the port in-service. The port service
state changes to IS-NR.
• IS,AINS—Puts the port in automatic in-service.
The port service state changes to
OOS-AU,AINS.
• OOS,DSBLD—Removes the port from service
and disables it. The port service state changes to
OOS-MA,DSBLD.
• OOS,MT—Removes the port from service for
maintenance. The port service state changes to
OOS-MA,MT.
Table 18-15 Line Options for the DS3XM-6 Parameters (continued)
Parameter Description Options

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform