17-71
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 17 DLPs A1 to A99
DLP-A64 Set the IP Address, Default Router, and Network Mask Using the LCD
Note This check box is active only if you selected a login group when you logged into CTC.
Step 4 Click OK.
After a few seconds, the new node appears on the network view map.
Step 5 Return to your originating procedure (NTP).
DLP-A64 Set the IP Address, Default Router, and Network Mask Using the LCD
Note You cannot perform this task if the LCD IP Display on the node view Provisioning > Network tab is set
to Display Only or Suppress Display. See “DLP-A249 Provision IP Settings” task on page 19-30 to view
or change the LCD IP Display field.
Note The LCD reverts to normal display mode after 5 seconds of button inactivity.
Step 1 On the ONS 15454 front panel, repeatedly press the Slot button until Node appears on the LCD.
Step 2 Repeatedly press the Port button until the following displays:
• To change the node IP address, Status=IpAddress (Figure 17-28)
• To change the node network mask, Status=Net Mask
• To change the default router IP address, Status=Default Rtr
Figure 17-28 Selecting the IP Address Option
Step 3
Press the Status button to display the node IP address (Figure 17-29), the node subnet mask length, or
the default router IP address.
Purpose This task changes the ONS 15454 IP address, default router, and network
mask using the LCD on the fan-tray assembly. Use this task if you cannot
log into CTC.
Tools/Equipment None
Prerequisite Procedures DLP-A36 Install the TCC2/TCC2P Cards, page 17-42
Required/As Needed Optional
Onsite/Remote Onsite
Security Level None
FAN FAIL
Slot
Slot-0
Status=IpAddress
44089
CRIT MAJ MIN
Status Port
To Next Page
Loading...
