Cisco ONS 15454 Series User Manual

5-18
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 5 Turn Up Network
NTP-A178 Provision a Traditional BLSR Dual-Ring Interconnect
Step 3 Verify that the BLSR DRI interconnect nodes have OC-N cards installed and have fiber connections to
the other interconnect nodes:
• The OC-N cards that will connect the BLSRs must be installed at the interconnect nodes.
• The interconnect nodes must have fiber connections. Figure 5-4 shows an example of fiber
connections for a traditional two-fiber BLSR DRI.
Figure 5-4 Traditional Two-Fiber BLSR DRI Fiber Connection Example
Stop. You have completed this procedure.
Node 1
West East
West East
West East
West
West
West
West
West East
East
East
East
East
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 4
Slot 1
Tx
Rx
Slot 12
Tx
Rx
Node 2
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 3
Slot 1
Tx
Rx
Slot 5
Tx
Rx
115256
Node 5
Slot 1
Tx
Rx
Slot 5
Tx
Rx
Node 8
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 6
Slot 1
Tx
Rx
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Slot 12
Tx
Rx
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 7
Slot 5
Tx
Rx
Slot 12
Tx
Rx

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform