Cisco ONS 15454 Series - NTP- A241 Provision G-Series Ports for Transponder Mode (Tx Mode)

6-79
Cisco ONS 15454 Procedure Guide, R5.0
August 2005
Chapter 6 Create Circuits and VT Tunnels
NTP-A241 Provision G-Series Ports for Transponder Mode (Tx Mode)
Figure 6-14 Two-Port Bidirectional Transponder Mode
Step 5
To put a G-Series card port in one-port bidirectional transponder mode (Figure 6-15):
a. Click the desired port row (for example, Port 1).
b. In the TXP Port column, choose the desired port from the drop-down list (for example, Port 1).
c. In the TXP Mode column, choose TX/RX from the drop-down list.
d. Click Apply.
In card view, the desired port has arrows and a curved line on the back of the port.