Cisco ONS 15454 Series - NTP- A203 Modify or Delete Card Protection Settings

10-4
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 10 Change Node Settings
NTP-A203 Modify or Delete Card Protection Settings
NTP-A203 Modify or Delete Card Protection Settings
Caution Modifying and deleting protection groups can be service affecting.
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66. If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-A108 Back Up the Database” procedure on page 15-4.
Step 3 Perform any of the following tasks as needed:
• DLP-A150 Modify a 1:1 Protection Group, page 18-20
• DLP-A152 Modify a 1:N Protection Group, page 18-21
• DLP-A154 Modify a 1+1 Protection Group, page 18-22
• DLP-A35 Modify an Optimized 1+1 Protection Group, page 17-41
• DLP-A155 Delete a Protection Group, page 18-23
Step 4 Complete the “NTP-A108 Back Up the Database” procedure on page 15-4.
Stop. You have completed this procedure.
NTP-A292 Modify or Delete Communications Channel
Terminations and Provisionable Patchcords
Purpose This procedure modifies and deletes card protection settings.
Tools/Equipment None
Prerequisite Procedures NTP-A170 Create Protection Groups, page 4-10
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This procedure changes or deletes SDCC and LDCC terminations and
deletes provisionable patchcords on the ONS 15454.
Tools/Equipment None
Prerequisite Procedures DLP-A377 Provision Section DCC Terminations, page 20-61 or
DLP-A378 Provision Line DCC Terminations, page 20-62 or
or
DLP-A367 Create a Provisionable Patchcord, page 20-51
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher