21-22
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 21 DLPs A400 to A499
DLP-A441 Install Electrical Cables on the UBIC-H EIAs
Figure 21-1 Fully Cabled UBIC-H (A-Side)
Step 5
If available, tie wrap or lace the cables according to Telcordia standards (GR-1275-CORE) or local site
practice.
Note When routing the electrical cables be sure to leave enough room in front of the alarm and
timing panel so that it is accessible for maintenance activity.
Step 6 Return to your originating procedure (NTP).
124534
To Next Page
Loading...
