10-6
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 10 Change Node Settings
NTP-A205 Modify Users and Change Security
Step 5 If you need to verify timing after removing a node from a BLSR or path protection, see the “DLP-A195
Verify Timing in a Reduced Ring” task on page 18-67.
Step 6 Complete the “NTP-A108 Back Up the Database” procedure on page 15-4.
Stop. You have completed this procedure.
NTP-A205 Modify Users and Change Security
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66. If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-A108 Back Up the Database” procedure on page 15-4.
Step 3 Perform any of the following tasks as needed:
• DLP-A271 Change Security Policy on a Single Node, page 19-53
• DLP-A272 Change Security Policy on Multiple Nodes, page 19-55
• DLP-A511 Change Node Access and PM Clearing Privilege, page 22-4
• DLP-A158 Change User Password and Security Level on a Single Node, page 18-25
• DLP-A160 Change User Password and Security Level on Multiple Nodes, page 18-26
• DLP-A159 Delete a User from a Single Node, page 18-26
• DLP-A161 Delete a User from Multiple Nodes, page 18-27
Step 4 Complete the “NTP-A108 Back Up the Database” procedure on page 15-4.
Stop. You have completed this procedure.
NTP-A87 Change SNMP Settings
Purpose This procedure modifies user and security properties for the ONS 15454.
Tools/Equipment None
Prerequisite Procedures NTP-A30 Create Users and Assign Security, page 4-4
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
Purpose This procedure modifies SNMP settings for the ONS 15454.
Tools/Equipment None
Prerequisite Procedures NTP-A256 Set Up SNMP, page 4-12
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
