20-34
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A348 Monitor PM Counts for a Selected Signal
DLP-A348 Monitor PM Counts for a Selected Signal
Step 1 In node view, double-click the card where you want to view PM counts. The card view appears.
Step 2 Click the Performance tab.
Note Different port and signal-type drop-down lists appear depending on the card type and the circuit
type. The appropriate types (DS1, DS3, VT path, STS path) appear based on the card. For
example, the DS3XM cards list DS3, DS1, VT path, and STS path PM parameters as signal
types. This enables you to select both the DS-3 port and the DS-1 within the specified DS-3.
Step 3 In the signal type drop-down lists, click the following options as appropriate:
• DS: n or Port: n (card port number)
• VT: n (VT path number)
• STS: n (STS number within the VT path)
Figure 20-5 shows the port and signal type drop-down lists on the Performance window for a DS3XM-6
card.
Purpose This task enables you to view near-end or far-end PM counts for a
specific signal (STSn), path (VTn), and port (DSn) on a selected card.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
Need help?
General
