20-39
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A353 Refresh FC_MR-4 PM Counts at a Different Time Interval
Step 2 Click the Performance > History tabs (Figure 20-8).
Figure 20-8 FC_MR-4 History on the Card View Performance Window
Step 3
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 4 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Prev-n columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in the
Cisco ONS 15454 Troubleshooting Guide.
Step 5 Return to your originating procedure (NTP).
DLP-A353 Refresh FC_MR-4 PM Counts at a Different Time Interval
Step 1 In node view, double-click the FC_MR-4 card where you want to view PM counts. The card view
appears.
Purpose This task changes the window view to display specified PM counts in
time intervals depending on the interval option selected.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
124906
History tab
Performance
tab
Card View
Refresh
button
Port
drop-down list
Interval
drop-down list
To Next Page
Loading...
