Cisco ONS 15454 Series - Table 18-7 Line Options for DS3-12 or DS3 N-12 Cards

18-33
Cisco ONS 15454 Procedure Guide, R5.0
March 2007
Chapter 18 DLPs A100 to A199
DLP-A166 Change Line and Threshold Settings for the DS3-12 or DS3N-12 Cards
Table 18-7 Line Options for DS3-12 or DS3N-12 Cards
Parameter Description Options
Port # Sets the port number. 1 to 12
Port Name Sets the port name. User-defined, up to 32 alphanumeric/special
characters. Blank by default.
See the “DLP-A314 Assign a Name to a
Port” task on page 20-8.
SF BER Sets the signal fail bit error rate.
• 1E-3
• 1E-4
• 1E-5
SD BER Sets the signal degrade bit error rate.
• 1E-5
• 1E-6
• 1E-7
• 1E-8
• 1E-9
Line Length Defines the distance (in feet) from
backplane connection to the next
termination point.
• 0 - 225 (default)
• 226 - 450
Admin State Sets the port service state unless network
conditions prevent the change.
• IS—Puts the port in-service. The port
service state changes to IS-NR.
• IS,AINS—Puts the port in automatic
in-service. The port service state
changes to OOS-AU,AINS.
• OOS,DSBLD—Removes the port from
service and disables it. The port service
state changes to OOS-MA,DSBLD.
• OOS,MT—Removes the port from
service for maintenance. The port
service state changes to OOS-MA,MT.