17-32
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 17 DLPs A1 to A99
DLP-A25 Install Coaxial Cable With BNC Connectors
DLP-A25 Install Coaxial Cable With BNC Connectors
Step 1 Place the BNC cable connector over the desired connection point on the backplane.
Figure 17-15 shows how to connect a coaxial cable to the BNC EIA using a right-angle BNC cable
connector.
Figure 17-15 Using a Right-Angle Connector to Install Coaxial Cable with BNC Connectors
Step 2
Position the cable connector so that the slot in the connector is over the corresponding notch at the
backplane connection point.
Step 3 Gently push the connector down until the notch backplane connector slides into the slot on the cable
connector.
Step 4 Turn the cable connector clockwise to lock it into place.
Step 5 Tie wrap or lace the cables to the EIA according to Telcordia standards (GR-1275-CORE) or local site
practice.
Step 6 Route the cables to the nearest side of the shelf assembly through the side cutouts according to local site
practice. The rubber-coated edges of the side cutouts prevent the cables from chafing.
Purpose This task installs the coaxial cable with BNC connectors.
Tools/Equipment None
Prerequisite Procedures DLP-A12 Install a BNC or High-Density BNC EIA, page 17-12
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
32075
To Next Page
Loading...
