3-5
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 3 Connect the PC and Log into the GUI
NTP-A236 Set Up a Remote Access Connection to the ONS 15454
Step 3 If your computer is connected to a proxy server, disable proxy service or add the ONS 15454 nodes as
exceptions. To disable proxy service, complete one of the following tasks, depending on the web browser
that you use:
• DLP-A56 Disable Proxy Service Using Internet Explorer (Windows), page 17-65
• DLP-A57 Disable Proxy Service Using Netscape (Windows and UNIX), page 17-66
Step 4 Continue with the “NTP-A23 Log into the ONS 15454 GUI” procedure on page 3-6.
Stop. You have completed this procedure.
NTP-A236 Set Up a Remote Access Connection to the ONS 15454
Step 1 Connect the modem to the RJ-45 (LAN) port on the TCC2/TCC2P card or to the LAN pins on the
ONS 15454 backplane.
Step 2 While referring to the modem documentation, complete the following tasks to provision the modem for
the ONS 15454:
• For CTC access, set the modem for Ethernet access.
• Assign an IP address to the modem that is on the same subnet as the ONS 15454.
• The IP address the modem assigns to the CTC computer must be on the same subnet as the modem
and the ONS 15454.
Note For assistance on provisioning specific modems, contact the Cisco Technical Assistance Center
(TAC). See the “Obtaining Documentation, Obtaining Support, and Security Guidelines” section
on page lvi for more information.
Step 3 Continue with the “NTP-A23 Log into the ONS 15454 GUI” procedure on page 3-6.
Stop. You have completed this procedure.
Purpose This procedure connects the CTC computer to an ONS 15454 using a LAN
modem.
Tools/Equipment Modem and modem documentation
Prerequisite Procedures
• NTP-A260 Set Up Computer for CTC, page 3-1
• A modem must be connected to the ONS 15454
• The modem must be provisioned for ONS 15454. To run CTC, the
modem must be provisioned for Ethernet access.
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
Need help?
General
