9-4
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 9 Manage Circuits
NTP-A151 Modify and Delete Circuits
NTP-A151 Modify and Delete Circuits
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66 at a node containing the circuit that you
want to modify. If you are already logged in, continue with Step 2.
Step 2 As needed, complete the “DLP-A230 Change a Circuit Service State” task on page 19-19.
Step 3 As needed, complete the “DLP-A231 Edit a Circuit Name” task on page 19-20.
Step 4 As needed, complete the “DLP-A232 Change Active and Standby Span Color” task on page 19-21.
Step 5 As needed, complete the “DLP-A233 Edit Path Protection Circuit Path Selectors” task on page 19-22.
Step 6 As needed, complete the “DLP-A263 Edit Path Protection Dual-Ring Interconnect Circuit Hold-Off
Timer” task on page 19-45.
Step 7 As needed, complete the “DLP-A333 Delete Circuits” task on page 20-21.
Step 8 As needed, complete the “DLP-A437 Change a VCAT Member Service State” task on page 21-15.
Step 9 As needed, complete the “DLP-A384 Add a Member to a VCAT Circuit” task on page 20-65.
Step 10 As needed, complete the “DLP-A385 Delete a Member from a VCAT Circuit” task on page 20-69.
Stop. You have completed this procedure.
NTP-A278 Modify and Delete Overhead Circuits
Caution Deleting circuits can be service affecting and should be performed during a maintenance window.
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66 for a node on the network where you want
to delete the circuit. If you are already logged in, continue with Step 2.
Purpose This procedure modifies and deletes ONS 15454 circuits and tunnels.
Tools/Equipment None
Prerequisite Procedures Circuits must exist on the network. See Chapter 6, “Create Circuits and VT
Tunnels” for circuit creation procedures.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This procedure changes the tunnel type, repairs IP circuits, and deletes
overhead circuits.
Tools/Equipment None
Prerequisite Procedures Circuits must exist on the network. See Chapter 6, “Create Circuits and VT
Tunnels.”
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
Need help?
General
